MadMonty Posted March 5, 2013 Report Share Posted March 5, 2013 I have an old Nacra 18. The cradles on the trailer rusted out and I have had new ones made. The originals were lined with carpet to protect the hull, but I am concerned that the carpet may have held moisture and contributed to the rust. Any tips on a lining that will protect the hulls and minimise moisture retention? Link to comment Share on other sites More sharing options...
symo_007 Posted March 5, 2013 Report Share Posted March 5, 2013 20mm high density foam ? Link to comment Share on other sites More sharing options...
QB2 Posted March 7, 2013 Report Share Posted March 7, 2013 You can get sheet rubber from clark rubber and teflon strips from boat chandleries Link to comment Share on other sites More sharing options...
Hawky Posted March 7, 2013 Report Share Posted March 7, 2013 [ATTACH=CONFIG]1183[/ATTACH] This how I set my h20 up note the cradle under the front beam csm mat and 2mm coremat Link to comment Share on other sites More sharing options...
cruiser Posted March 7, 2013 Report Share Posted March 7, 2013 closed cell foam, like an exercise matt you'd buy from a $2 shop. Contact cement and its all good Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.