lindsay s Posted February 4, 2015 Report Share Posted February 4, 2015 Hi everyone.I'm planning to swap my port hull for an undamaged one. However my front inside beam bolt is not directly underneath the hole, but off to the side, meaning I can't use a socket.Any suggestions?Lindsay Link to comment Share on other sites More sharing options...
darcy1945 Posted February 4, 2015 Report Share Posted February 4, 2015 Let the tension off the dolphin striker, if that is not the problem, the, grind or file the hole far enough to get your socket on it. Link to comment Share on other sites More sharing options...
Idle Posted February 4, 2015 Report Share Posted February 4, 2015 With mine like that, when you release the outside bolt (i.e. the other one on that hull) then there was enough movement to allow me to get a socket on it. Note: I didn't do it, I watched Mark and Mick do it a year ago, so there may have been some other magic that I didn't spot them doing as a newbie. Link to comment Share on other sites More sharing options...
korwich Posted February 9, 2015 Report Share Posted February 9, 2015 How did it all go Lindsay? did you get the sucker out or not? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.